Marmitek AWM2P Instrukcja Użytkownika Pobierz pdf (Strona 8)

8 © MARMITEK

White: Input 2, second address

When the red wire is connected to the phase wire, the programmed

“address +1” will be transmitted (e.g. when A3 is programmed as the

base address then the Marmitek X-10 address A4 will be sent by using

input 2). If the status in the MicroModule was ON, an OFF command

will be transmitted. If the status in the MicroModule was OFF, an

ON command will be transmitted. Through this transmission, other

Marmitek X-10 modules can be switched remotely over the power

line or Macro’s setup in the computer interface can be activated.

Mounting Instructions

RNING! ALWAYS SWITCH OFF THE MAIN MASTER SWITCH

BEFORE INSTALLING THE MICROMODULE.

To install the MicroModule AWM2P the following wiring is

required.

Neutral

2. Phase 230V

3. Load. This wire runs directly to the load.

Figure 1

• Take the present switch (if one is installed) out of the wall outlet

box.

• D

isconnect all wires from the switch.

• Pull an additional Neutral-wire in case this one is missing.

Blue (N)

Brown

(L)

Black

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Brak uwag

Marmitek AWM2P Instrukcja Użytkownika Strona 8