Marmitek AWM2P Instrukcja Użytkownika Pobierz pdf (Strona 14)

14 © MARMITEK

when the range of your remotes is not sufﬁcient. The TM13 is using

so called collision detection to prevent signals to be disturbed when

more than one TM13 is transmitting. TM13’s will wait for a quite

power line before transmitting their data. To prevent your Marmitek

X-10 System to become slow or to prevent dimming from becoming

less smooth, make sure that the TM13 units are placed as far away

from each other as possible.

Can I use more switches to control the AWM2P?

Yes, you can connect more switches to the ﬁrst switch. However, they

all need to be normal switches (on-off) or all Momentary switches.

Do you still have questions?

Please check out www.marmitek.com for more information.

TECHNICAL DATA

Pow

er: 230V ±10%, 50 Hz

Electricity consumption < 30 mA capacitive

Switching power: 3600W 230V with temperature

and mounting restrictions.

2300W/230V 500W ind cap

Signal transmission: > 5Vpp in 5 Ohm at 120 kHz

± 1kHz

X-10 transmission: 1 pulse burst on 0˚ and 180˚

Signal sensitivity: 25mVpp … 6 Vpp at 120 kHz

± 4kHz

Signal / noise ratio: 1,35 : 1

X-10 Key codes: All units Off, All Lights On,

On, Off, Status Request.

Switch use: normal switches (make/break)

or Momentary switches

Connection range: Up to 2,5 mm

Environment temperature: -10°C to +35°C (operation)

-20°C to +70°C (storage)

Dimensions: 46x46x16mm.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Brak uwag

Marmitek AWM2P Instrukcja Użytkownika Strona 14